Description
Court order functionality has been available in the PayrollAccounting component since 3.0F. Due to the extensive modificationsmade to this functionality in Release 4.5A, the conversion programRPUCOUG0 is provided in this Release to perform the necessaryconversions. This report works on the payroll results and Infotype 70(Court Orders GB) as follows:
New infotype subtypes have been introduced in Release 4.5A. Oldsubtypes are therefore converted as follows:
England/Wales:
N: EWN
P: EWP
C: EWC
T: EWT
D: CSD
Northern Ireland:
N: NIN
P: NIP
D: CSD
Scotland:
M: SCMA
S: SEA
D: CSD
The court order wage types available prior to 4.5A are converted asfollows in the RT and CRT tables:
/Cx1,,,,/CO1
/Cx2,,,,/CO2
/Cx3,,,,/CO3
/Cx4,,,,/CO4
OBJPS field is now handled differently on IT0070
Whenever a new court order type was created, the P0070-OBJPS wasassigned the value 01. If such a subtype already existed, theP0070-OBJPS was increased by 1.
Now each time a court order is created, the P0070-OBJPS field isassigned a sequential value, irrespective of the court order type.
Table V0 is used instead of the CNTR3 field on the RT
The OBJPS of the processed court order used to be stored in the CNTR3field on the RT. Now the new fields V0TYP and V0ZNR are used on the RTto store the entry type ('G' for British garnishment) and object ID.
The table V0 is used to record information besides the OBJPS. TheV0-V0TYP is assigned the value 'G' (for British garnishment), anddetailed information (the court order type and OBJPS) is assigned tothe field V0-VINFO.
RESET N1

Running RPUCOUG0
It is important that you set the parameters correctly before you runthis report:
Enter the personnel number, or range of personnel numbers, and payrollarea.
Then enter the region in which you are operating the court orders.
Enter the tax year(s) for which you want to convert the payrollresults.
Specify whether you want to run the report in test mode.
RESET N1

Output
If you run the report in test mode, it will display a message if theperson concerned does not have an Infotype 70 record. Otherwise, itwill display the details of the conversion of the old subtype to thenew subtype, and the old object ID to the new object ID.
You should check these results to ensure that the conversion iscorrect. You can then go on to run the report properly.
When you run the report for real, the system displays a messageinforming you that the cluster RG and Infotype 70 were converted forthe specific personnel number. If errors occur, an error message isdisplayed.

Example
The following is an example of the data output when the report is runin test mode.
Please compare old Subty with new Subty, and old ObjID with new ObjIDfor 1234:
Pers. No.,,Old Subty,,New Subty,,Old ObjID,,New ObjID
00001234,,N,,EWN,,01,,01
00001234,,C,,EWC,,01,,02