Programme SAP GRAPHICS_IGS_RSPO_TEST - Report GRAPHICS_IGS_RSPO_TEST

Purpose
Use this program to check SNMP Printer Status feedback via RspoConnectorInterpreter of the IGS.

Prerequisites
The IGS must be installed and run against this system.
An RFC destination must be maintained in transaction SM59. You can findmore information about this in the note 454042.
A printer must be set up in transaction SPAD that supports SNMP statusfeedback. This printer has to set up with Access Method S, L, U or C.
Access Method L, U, C printers must have a network name or IP addressspecified in its SPAD definition. Use tab 'Access Method' and button'SNMP' in transaction SPAD to specify this information.
An Access Method S printer does not need to have its network name or IPaddress specified in SPAD. Since such a printer is accessed fromSAPSprint its printer status may be queried from SAPSprint as well.SAPSprint need to support protocol version 229 for the SNMP query (usecommand 'sapsprint -v' to check out the protocol version of SAPSprint.The SAPSprint protocol version has to be explicitly mentioned in theoutput of that command. If not the protocol version of SAPSprint islower than 229. Furthermore make sure that on the OS side the associatedprinter is connected via a TCP/IP port to the machine SAPSprint isrunning on. If not SAPSprint may not be able to query its status.
If an Access Method S printer has its IP address or network namespecified in its SPAD definition, the system will try to access theprinter directly and not via SAPSprint.

Selection
Enter the RFC destination of IGS.
Enter the name of a printer that supports SNMP printer status feedback(see section prerequisites).

Output
The following information should be displayed:
·,,Is IGS reachable.
·,,Is RspoConnector Interpreter loaded from IGS.
·,,Does the specified printer support SNMP printer status feedback.
·,,Could the printer be queried for status feedback.
·,,Printer status.

Activities
Carry out the test in SE38 as follows:
·,,Choose F8.
·,,Enter the RFC destination of IGS.
·,,Enter the name of a printer that supports SNMP printer statusfeedback (see section prerequisites).
The following information should be displayed:
·,,Is IGS reachable.
·,,Is RspoConnector Interpreter loaded from IGS.
·,,Does the specified printer support SNMP printer status feedback.
·,,Could the printer be queried for status feedback.
·,,Printer status.